LV-Pack

Steam Outputs from 600 kg/h to 8400 kg/h As a recognised specialist in the manufacture of electric boilers with immersion heaters for over 50 years, Babcock Wanson is offering the LV-Pack series to help manufacturers meet European requirements for energy optimisation and reduction of greenhouse gas emissions. The LV-Pack is a low-voltage industrial electric boiler specially designed to offer maximum efficiency with zero CO2 and NOx emissions.

Environmentally friendly

The industrial electric boiler LV-Pack boiler offers many environmental and operational benefits: It does not consume any fossil fuel and therefore does not release any gaseous effluents into the atmosphere. From this pesrpective, the installation is very easy: There is no requirement for chimneys, fuel supply networks or storage tanks. In addition, no periodic monitoring of atmospheric emissions is required. Efficiencies over 99% can be achieved since all incoming electrical energy is converted into thermal energy (only minor heat losses through the surfaces are to be deducted). Precise pressure control with multiple power stages allow the boiler to react quickly to load changes. This makes it possible to make quick starts to absorb available grid power when needed.

Robust construction for increased lifespan

LV-Pack boilers are made up of steel shells and flat bottoms held in place by tie rods that accommodate immersion heaters, offering numerous advantages in terms of performance, implementation and also for periodic maintenance operations. They are designed to allow both quick start-up and quick steam production, while protecting the immersion heaters from excessive stresses.

Economical Exploitation

The control and instrumentation allow exclusive Babcock Wanson operating modes that adapt to the constraints of all industrial processes. The boiler is equipped with the Navinergy monitoring interface, which enables both on-site and remote monitoring of operating parameters.

Easy installation and commissioning

The boiler is delivered ready to operate. All that is required is to connect it to the electricity, the feed water and the steam network.

Why Choose the LV-Pack Electric Boiler?

  • Zero emission on site (CO2 – NOx – SOx)
  • 100% efficiency
  • High turndown ratios
  • Easy maintenance
  • Robust construction for long life
  • Connectivity with our system Navinergy
  • Easy and flexible mode of operation
  • High availability
  • Easy to install
  • Reduced operating costs

LV-Pack Electric Boiler

LV-Pack model 600 900 1200 1500 1800 2250 3000
Steam Output (1) kg/h 600 900 1200 1500 1800 2250 3000
Power Output (1) kW 400 600 800 1000 1200 1500 2000
Nominal voltage V  400 ou 690  400 ou 690  400 ou 690 690 690 690 690
Width I (2) mm  1400 1400 1700 1700 1700 2000 2000
Length L2 mm  3400 3400 3400 3400 3400 3400 3400
Height H2 mm  1930 1930 2250 2250 2310 2610 2695
Weight fully flooded kg (+/-10%)  3900 3900 5400 5500 5500 7600 7600
Immersion heater on both side  NO NO NO NO NO NO NO

(1) Power output at up to 8 barg based on feedwater at 95°C.

(2) Width (I) given without control cabinet depth (additional width of 500 mm to be considered)

Standard design pressure: 15 barg – Specific max. design pressure: 18 barg

LTP : 1000 mm minimum

LV-Pack model 3600 4200 4800 5400 6000 6600 7200 7800 8400
Steam Output (1) kg/h 3600 4200 4800 5400 6000 6600 7200 7800 8400
Power Output (1) kW 2400 2800 3000 3600 4000 4400 4800 5200 5600
Nominal voltage V 690 690 690 690 690 690 690 690 690
idth I (2) mm 2010 2010 2010 2010 2410 2410 2410 2410 2410
Length L2 mm 4490 4490 4490 4490 4490 4490 4490 4490 4490
Height H2 mm 2355 2355 2410 2410 2810 2940 2940 2940 2940
Weight  fully flooded kg (+/-10%) 10500 10600 10600 12200 12600 16100 16200 16200 16300
Immersion heater on both side YES YES YES YES YES YES YES YES YES

(1) Power output at up to 8 barg based on feedwater at 95°C.

(2) LWidth (I) given without control cabinet depth (additional width of 500 mm to be considered)

Standard design pressure: 15 barg – Specific max. design pressure: 18 barg

LTP : 1000 mm minimum

The dimensions and characteristics of the power cabinets can be found in the brochure.